These are instructions for the Astropixel FLD Mount from LayerPrinter Etsy Shop.
Place the Astropixel boards on the back of the mount and secure with the provided screws. Do not overtighten the screws, the screws should be slightly touching the boards, they do not need to be tight.
Insert the stock screws into the dome most of the way leaving a small gap for the mount to slip into place.
Slip the mount under the screws and while pressing firmly against the dome, finish tightening the screws. Depending on your screwdriver, you may need to remove the lower ring from the dome to have better access to the screws.
Thats it, finish the wiring following the Astropixel instructions.
